Skip to main content
Skip table of contents

Disconnect or Delete Clusters

Disconnect or delete a cluster

Disconnect vs. Delete

When you attach a cluster to your environment that was not created with Kommander, you can later detach it. This does not alter the running state of the cluster, but simply removes it from the DKP UI. User workloads, platform services, and other Kubernetes resources are not cleaned up at detach.

After successfully detaching the cluster, manually disconnect the attached cluster's Flux installation from the management Git repository. Otherwise, changes to apps in the managed cluster's workspace will still be reflected on the cluster you just detached. Ensure your dkp configuration references the target cluster. You can do this by setting the KUBECONFIG environment variable to the appropriate kubeconfig file location. An alternative to initializing the KUBECONFIG environment variable is to use the –kubeconfig=cluster_name.conf flag. Then, run kubectl -n kommander-flux patch gitrepo management -p '{"spec":{"suspend":true}}' --type merge to make the cluster's workloads not managed by Kommander, anymore.

If you created a managed cluster with Kommander, you cannot disconnect the cluster, but you can delete the cluster. This completely removes the cluster and all of its cloud assets.

We recommend deleting a Managed cluster via the DKP UI. Deleting clusters via the CLI will not remove all DKP resources, in which case you will have to follow the troubleshooting instructions to finalize the detachment.

If you delete the Management (Konvoy) cluster, you can not use Kommander to delete any Managed clusters created by Kommander. If you want to delete all clusters, ensure you delete any Managed clusters before finally deleting the Management cluster.

Statuses

See Statuses for a list of possible states a cluster can have when it is getting disconnected or deleted.

Troubleshooting

I cannot detach an attached cluster that is “Pending”

OR

The cluster I deleted via CLI still appears in the UI with “Error” state

Sometimes detaching or deleting a Kubernetes cluster causes that cluster to get stuck in a “Pending” or “Error” state. This can happen because the wrong kubeconfig file is used, or the cluster is just not reachable. In order to detach the cluster, so it does not show in the UI, follow these steps:

  1. Determine the KommanderCluster resource backing the cluster you tried to attach:

    CODE
    kubectl -n WORKSPACE_NAMESPACE get kommandercluster

    Replace WORKSPACE_NAMESPACE with the actual current workspace name. You can find this name by going to https://YOUR_CLUSTER_DOMAIN_OR_IP_ADDRESS/dkp/kommander/dashboard/workspaces in your browser.

  2. Delete the cluster:

    CODE
    kubectl -n WORKSPACE_NAMESPACE delete kommandercluster CLUSTER_NAME
  3. If the resource does not go after a short time, remove its finalizers:

    CODE
    kubectl -n WORKSPACE_NAMESPACE patch kommandercluster CLUSTER_NAME --type json -p '[{"op":"remove", "path":"/metadata/finalizers"}]'

    This removes the cluster from the DKP UI.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.