In a Kubernetes cluster, depending on the flow of traffic direction, there are two kinds of load balancing:
- Load balancing for the traffic within a Kubernetes cluster
- Load balancing for the traffic coming from outside the cluster
Load balancing for internal traffic
Load balancing within a Kubernetes cluster is accessed through a
ClusterIP service type.
ClusterIP presents a single IP address to the client and load balances the traffic going to this IP to the backend servers.
The actual load balancing happens using
iptables or IPVS configuration. The
kube-proxy Kubernetes component programs these.
iptables mode of operation uses DNAT rules to distribute direct trafik to real servers, whereas IPVS leverages in-kernel transport-layer load-balancing.
A comparision between these two methods can be found here.
kube-proxy runs in
The kube-proxy configuration can be altered by updating the
kube-proxy configmap in the
Load balancing for external traffic
External traffic destined for the Kubernetes service requires a service of type
LoadBalancer, through which external clients connect to your internal service.
Under the hood, it uses a load balancer provided by the underlying infrastructre to direct the traffic.
In the Cloud
In cloud deployments, the load balancer is provided by the cloud provider. For example, in AWS, the service controller communicates with the AWS API to provision an ELB service which targets the cluster nodes.
For an on-premises deployment, Konvoy ships with MetalLB, which provides load-balancing services.
To use MetalLB:
- Identify and reserve a virtual IP (VIP) address range in your networking infrastructure.
NOTE: Make sure the MetalLB subnet does not overlap with
- Configure your networking infrastructure so that the reserved IP addresses is reachable:
- from all hosts specified in the inventory file.
- from the computer used to deploy Kubernetes.
Your configuration is complete If the reserved virtual IP addresses are in the same subnet as the rest of the cluster nodes. If it is in a different subnet you may need to configure appropriate routes to ensure connectivity with the virtual IP address. If the virtual IP addresses share an interface with the primary IP address of the interface, you must disable any IP or MAC spoofing from the infrastructure firewall.
MetalLB can be configured in two modes: Layer2 and BGP.
The following example illustrates the Layer2 configuration in the
cluster.yaml configuration file:
kind: ClusterConfiguration apiVersion: konvoy.mesosphere.io/v1beta2 spec: addons: addonsList: - name: metallb enabled: true values: |- configInline: address-pools: - name: default protocol: layer2 addresses: - 10.0.50.25-10.0.50.50
The number of virtual IP addresses in the reserved range determines the maximum number of
LoadBalancer service types you can create in the cluster.
bgp mode implements only a subset of the BGP protocol. In particular, it only advertises the virtual IP to peer BGP agent.
The following example illustrates the BGP configuration in the
cluster.yaml configuration file:
kind: ClusterConfiguration apiVersion: konvoy.mesosphere.io/v1beta2 spec: addons: addonsList: - name: metallb enabled: true values: |- configInline: peers: - my-asn: 64500 peer-asn: 64500 peer-address: 172.17.0.4 address-pools: - name: my-ip-space protocol: bgp addresses: - 184.108.40.206/24
In the above configuration,
peers defines the configuration of the BGP peer, such as peer ip address and
autonomous system number (
address-pools section is similar to
layer2, except for the protocol.
MetalLB also supports advanced BGP configuration, which can be found here.
kubectl -n kubeaddons delete pod -l app=metallb,component=controller